diesel Fuel incinerators

16. The supplier must provide necessary information for the best of the installation. This incinerator with “PYROLYTIC”

combustion must have:

17. A combustion chamber of waste:

 Perfectly tight door for the manual loading of waste. The loading should be manual, batch load.

 A burner of lighting which the use is limited to the ignition of waste.

 Frontage of loading with door seals gone up on hinges, wheel of screw plug, flexible joint, and stuffing insulating out

of refractory.

 The insulation of the combustion chamber should be composed of refractory bricks, having a high content of aluminium and

insulates bricks in order to assure a minimum temperature on the outside sheet metal.

 Composition of the refractory;

 Refractory concrete:

 Thickness :>100mm

 Nature: 42% of Al203

 Insulate in fibrous panels:

 Thickness: >75mm

 Nature: Calcium silicate.

 Burner of lighting of waste, with fuel, standard mono-bloc casting guiding plunging flame, lighting and safety of

electronic ignition, permanent ventilation, electromagnetic sluice gate of regulation and isolating valve.

 Plate of combustion in Carborundum, avoiding the fixing of glass and slags.

18. A chamber of post combustion of gases

 A burner of combustion of gases,

 A device of injection of air allowing a total re-combustion of gases,

 A device of air inlet of cooling of waste gases,

 A sheath of evacuation of the gases burnt,

 Carcass in strong sheet steel with support of connection

 Composition of the refractory;

 Refractory concrete:

 Thickness :>150mm

 Nature: 65%% of Al203

 Insulate in fibrous panels:

 Thickness: >85mm

 Nature: Calcium

 Burner with fuel, mono-bloc casting guiding type with horizontal flame, lighting and safety of electronic ignition,

permanent ventilation, electromagnetic sluice gate of regulation and isolating valve.

 A secondary injection of air to ensure perfect oxygen content.